Coming Up Short

Written by Admin on . Posted in PCB Assembly and component

In another PCB assembly challenge, the customer’s BoM called for a through-hole header part to be installed on a circuit board, a mixed technology (SMT and PTH) assembly. A problem became immediately apparent with the first PCB that our operators began to assemble; this was a very thick circuit board (12.15mm thick), but the part specified and received did not have terminal pins long enough to protrude all the way through the PCB to other side (bottom side) (Figure 1). Obviously, we needed the pins to penetrate all the way to the bottom side and protrude so that they could be properly soldered using wave or selective soldering techniques.

shorty - pcb assembly

Figure 1. Original part’s through-hole pins are not long enough to go through the board and be soldered from the bottom side.

 

Shorty- PCB Assembly

Figure 2. Cross-section of PCB showing penetration depth of part’s original pins.

What to do?

In this instance, a replacement part with pins of sufficient length simply wasn’t available. The easiest solution (although labor-intensive) required manual removal of all the original pins from the part, and their replacement with longer pins of sufficient length, actually, to form good and robust solder joints on the bottom side of the PCB assembly (Figure 3). Once the longer pins were added, it became a simple matter to re-insert the through-hole header part and solder it in place from the bottom. The parts of the pin protruding from the solder joint could then be dealt with the same way as any other soldered through-hole pins.

Shorty pcb assembly 3

Figure 3. Side view showing new pin length (inset: bottom side view).

By Roy.

Are You Looking for quickturn prototype ‪‎PCB‬ manufacturing & assembly of high quality? ‪‎RUSHPCB‬ is one-stop shop for design, fabrication & assembly of ‪‎PCBs‬. www.rushpcb.com Call: 1 408 496 6013 Email: sales@rushpcb.com

Trackback from your site.

Leave a comment