As recently as 2000,filling a via was considered aspecialtyprocess limited to a small group of product applications and almostexclusivelyto one material, i.e., conductive ink. Furthermore, this process was dominated by one primary filling material, DuPont CB100.The through-hole viaswere filled so that a copper cap could be plated over the viasurface to create a solderable land on top of the via, and thus ‘Via-in-Pad’, or VIP.
This process enhanced the reliability of blind and buried vias formed during sequential lamination of sub-assemblies. A fully-filled via prevented air, moisture or gas entrapment in the via that could later expand during thermal cycles and result in delamination or barrel cracks.
We also learned that a filled via would prevent chemicals from seeping into these blind/buried vias during manufacturing or assembly. Such seepage could potentially attack or otherwise compromise the copper plating.
When it was introduced, via fill was used for high reliability end-products. Over the past 10-15 years, however,the reasonsto fill vias have greatly expanded, as so has the range of market sectors in which this technique is employed.As the sizes of packages are overall growing smaller, designs require VIP technology. This is why the demand for via filling has increased.
We also have seen the emergence of alternatives to DuPont CB100.Some have proved to be, depending on the application and the market sector,as good or even better suited to the product’s design and application.
Today there are also othereffective conductive inks on the market;Tatsuta, for example,is one thatusescopper for conductive particles ratherthanthe silver found in CB100. (Keep in mind that these inks are being used to fill copper-plated holes). It costs less (copper content vs. silver), and in our experience provides excellentperformance and reliability.
Now let’s consider the example of two different via structures on one PCB. One uses conductive ink for via fill, and the other non-conductive ink.For a decade we’ve been debating whyand/or when to select aconductive ink over a non-conductive ink for via fill.
Originally, it was believedthat conductive inks were required in order to effectively plate a copper cap over the via, and early on there was some validity to thispoint of view. Again, in our experience, non-conductive inks such as San-Eli andPetershave clearlydemonstratedcompatibilitywith metallization. They lend themselves to a well-bonded copper cap, plated over the ink surface (VIP).This is facilitated by a fortunate coefficient of expansion compatibility between the copper and the non-conductive fill.
Some believed that conductive inks provided a redundant connection which would act as security for defective vias, and that the presence of conductive particles in the ink added another layer of reliability and continuity in the event the copper plating in the via cracked or was otherwise compromised. But many don’t agree, feeling that the focus should obviously be on the PCB manufacturing process to ensure reliable vias. Besides, when one measures the conductivity or the resistance of conductive via fill inks, they fall far short of performing in the role of a redundant connection. Solid copper makes a far better electrical connection.
Many non-conductive inks have CTE and TGvalues that more closely match the PCB material than do those of conductiveinks. These non-conductive inks will expand and contract at the same rate and manner as the board material. This helps limit delamination or broken vias caused bymismatched thermal expansion. Non-conductive inks are reliable, easy to metallize (plating a cap over the top), less expensive, and quite efficient for filling small holes and micro vias.
In summary, whereas conductive inks(or only specific ones or one) were once considered the only option, we now find many non-conductive inks that are superior in performance, and much less expensive than conductive inks. They are worthy of consideration for substitution in applications where only a limited few specific brands and formulas of conductive inks were considered the only option.
Trackback from your site.