Archive for October, 2016

Mistakes to Avoid for Quickturn PCBs

Written by Admin on . Posted in PCB

circuit-1357939_960_720

There is no doubt about the importance of your quickturn project, deciding which fabricating company will determine just how successful and quick it will be. The truth is that the company you choose will determine the success of the project and the peace of mind you will have during the process. Keeping this in mind, knowing what to look for in the PCB experts you hire becomes the most important decision you will make. When shopping around for your printed circuit board experts, be sure to find out important information such as they type of support they will offer, unnecessary multiple laminations, and the adding in of via-in-pads.

Support

Finding a company that provides support with experts on hand to assist their clients every step of the way, should be on the top of your list of must-haves. Your project is too important to hand over and then be kept in the dark about any issues that may arise during the fabrication process. Knowing that all of your questions and concerns will be immediately addressed and answered satisfactorily will make the process run much more smoothly for everyone involved in the project.

Multiple Laminations

Because each lamination cycle means that the board must go through each phase of fabrication, time can become a concern. This is especially true for quickturn PCB projects. You will want to make sure that your board will not be placed through any unnecessary lamination cycles. This does not mean you should refuse them; however, this topic should be discussed and agreed upon so there will not be any unexpected delays that will hold up the completion of your quickturn printed circuit board. It will also enable you to get an accurate completion date so you can plan accordingly.

Via-in-Pads

Since adding via-in-pads adds an extra day to the project, you will want to make sure that it is not added in unless absolutely necessary. You will need to speak to the manufacturing company to find out if adding them is an absolute necessity or if it is acceptable not to add them in. Communication is a key; once again, the directive must be clear to avoid a step that will cause a delay in your quicktun project.

The best way to avoid mistakes for your quickturn PCB project is to know and trust the fabrication company you are entrusting your design too. They should be willing to work with you every step of the way and answer all of your questions happily and more importantly correctly. You will also want to make sure that they will not perform any unnecessary steps that will cost valuable time that turns your quickturn project into one that feels like it will never be completed. Research the fabricator before you speak with them and have a list of questions ready to test them. If their answers do not satisfy you, then chances are good they are not the right company for your quickturn project.